Haes SZAOV, Installation, Commissioning & Operating Manual, Page: 33 / 45

Single zone AOV User Manual SETUP AND PROGRAMMING
33
Approved Document Ref: UI-SZAOV-01 Issue 2.01
The General Alarm, General Fault & General Disablement LEDs will show the current attribute
settings for that circuit (see table below).
With the required LED lit, press the
ENTER button to enter ‘editing mode’.
The General Alarm LED will now pulse to indicate the editing of attribute 1 (alarm latching) for the
selected circuit (see table below).
Use button 1 to scroll to the attribute that requires editing, indicated by a pulsing LED as per table
below.
Use button 2 to switch the attribute ON or OFF.
Then use button 1 to move to the next attribute, if required.
Press the ENTER button to return to the circuit selection, indicated by a steady circuit LED.
When all required selections have been made, press and hold key 1 for more than 4 seconds to
save the settings.
3121 Input Circuit Function Settings
Attributes Detector Input Open Input Close Input
LED Status
Fast Pulse Slow
Pulse
Fast
Pulse Slow
Pulse Fast
Pulse Slow
Pulse
CIRCUIT LATCH
(Gen Alarm LED)
*
Latching Non
Latching
Latching
*
Non
Latching
Latching
*
Non
Latching
SHORT CIRCUIT
(Gen Fault LED)
Short cct
= alarm
*
Short cct
= fault
Short cct
= alarm
*
Short cct
= fault
Short cct
= alarm
*
Short cct
= fault
DETECTOR
REMOVAL
(Gen Disable LED)
*
Detector
Removal
On
Detector
Removal
Off
Default Setting indicated by *.
LED status when NOT in Edit Mode:
•
Fast Pulse Status is indicated by a steady LED.
•
Slow Pulse Status is indicated by an off LED.