Single zone AOV User Manual
SETUP AND PROGRAMMING
29
Approved Document Ref: UI-SZAOV-01 Issue 2.01
Level 3 Engineering Options
A series of programmable engineering options are available. These programming modes are
initiated by entering a four-digit code using buttons 1 - 4 on the keypad followed by the ENTER
button.
To access Level 3 options, first set switch 6 (PROG MODE) on the 7-way DIL switch located on
the main PCB to the ‘ON’ position (down). Then activate the controls by turning the key switch or
by entering the four-digit code (see Activate Controls in the OPERATING section).
The ‘Access Level’ indicator will pulse rapidly to signify that Level 3 access is active.
When finished programming, press and hold button 1 for 3 seconds to exit programming mode.
Return switch 6 to the ‘OFF’ position (up).
Set Factory Settings
Reset All Disablements, Test Modes and Parameters back to factory
settings.
Enter the required code as above and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds. All disablements, test mode settings
and engineering option parameters will revert to factory settings.
The panel will bleep to acknowledge the reset.
1
1
1
3
Summary of Contents for SZAOV
Page 45: ...www haes tech com ...