19
9.
Troubleshooting
The machine does not weld, and the LED
(lamp) does not light yellow or red.
• Check whether the machine is
connected to 230V electricity supply
and if the network is working.
• The control panel is damaged.
The machine does not weld. The LED
(lamp) has yellow light, but it does not
change red when closing the handle.
• Make sure that the handle is pressed
down with enough strength. (Do not
press the handle sideways.)
• Check whether the front cap is on the
handle and the magnet is in it.
• The control panel is damaged.
The machine does not weld; the LED
(lamp) is lit appropriately (yellow/red
changes operationally).
• Unplug from the electricity supply
without delay. Check that the sealing
wire, the teflon tapes and the
transformer are intact.
The sealing is not acceptable.
• Change the sealing time with the
regulatory button. (The sealing time
increases proportionally with the width
of the film.)
• Make sure that you wait for the
adequate cooling time after sealing. (1-
2 sec.) The cooling time increases
proportionally with the sealing time.
The handle clacks sideways, it is loose.
• The hinge bolts have to be fastened.
When connecting to the electricity supply
the sealing wire start to heat up
immediately.
• The control panel is damaged. Unplug
from the electricity supply without delay
and refer to the repair facility.
