12
Cut the lower self adhesive teflon tape (Figure 6 “5”) on
each side 4 mm longer than the side panel of the
aluminium machine unit in order to prevent electric short
circuit.
Use only original HACONA spare parts.
The surface of the sealing wire (Figure 6 “4”) can never
be taped, it has to be able to move freely under the upper
teflon strap. The upper teflon strap is not adhesive all the
way.
Note: When changing the teflon tape always check whether the teflon
tape under the sealing wire is intact. When changing the sealing wire it is
advisable to put on the protective cap of the backwards sealing wire
tensioning unit.
8.2.2. How to replace the silicone rubber
Pull out the damaged or burnt silicone rubber (profile) from the sealing
bar and clip in a new silicone rubber
(Figure 7)
.
The silicone rubber does not have to be pulled in the
profile. It can be clipped in easily.
When putting the silicone rubber in, watch out for the
direction of the profile. Looking from the sealing bar as it
opens the profile should look like the picture. (Figure
7).
HAZARD OF ACCIDENT.
When changing the silicone rubber be careful with the
sharp knife built in the sealing bar’s knife assembly
(Figure 7).
