Hach Lange CL17, Instrument Manual

Page: 13 / 74

Page 11
54400_install.fm
Installation
Section 1 Installation
DANGER
This instrument should be
installed by qualified technical
personnel to ensure adherence to
all applicable electrical and
plumbing codes.
DANGER
Cet appareil doit être installé par du personnel technique qualifié, afin d'assurer
le respect de toutes les normes applicables d'électricité et de plomberie.
PELIGRO
Este instrumento debe ser instalado por personal técnico capacitado para
assegurar el cumplimiento con todos los códigos eléctricos y de plomería
aplicables.
GEFAHR
Um zu gewährleisten, daß alle elektrischen und sanitärinstallationstechnischen
VDE-Vorschriften und gegebenefalls die Zusatzvorschriften der zuständigen
Elektrizitäts- und Wasserwerke erfüllt werden, darf dieses Gerät nur von
geschultem Fachpersonal installiert werden.
PERIGO
Este instrumento deve ser instalado por pessoal técnico qualificado para
asegurar o cumprimento de todas as normas elétricas e de canalização
aplicáveis.
1.1 Unpacking the Instrument
Remove the analyzer from its shipping carton and inspect it for any damage.
Verify that the Installation Kit, Cat. No. 55164-00, and Maintenance Kit,
Cat. No. 54443-00, are included in addition to reagents.
If damage is evident or the shipment is incomplete, please contact the
Customer Service Department, Hach Company, Loveland, Colorado for
instructions. The toll-free number is 800-227-4224. Contents of the
Installation and Maintenance kits are listed in on
Replacement Items on
page 67 .
1.2 Instrument Environmental Considerations
The instrument enclosure is designed for general-duty, indoor installation with
a nearly constant ambient temperature between 5° and 40 °C (18° to 104 °F).
The enclosure environmental rating is IP62 with the door closed and latched.
Do not mount the instrument in direct sunlight; shield from dripping water.
1.3 Mounting the Instrument on the Wall
The instrument case is designed for wall mounting. Refer to Figure 1 ,
Figure 2 , and Figure 3 for dimensions and other installation information. Use
¼-inch screws for mounting. Mount the instrument as close to the sampling
point as practical to ensure complete purging of the sample line during each
cycle. Leave adequate clearance at the sides and bottom of the instrument
case for plumbing and wiring connections.
!