Lifting, handling and storing
4
Make sure that the lifting equipment (e.g.: crane, hook, eye bolt, straps, etc.) are suitable for the weight and size of the gear
reducer (consult Rossi technical catalog for dimensions and weight).
For the lifting and transport of gear reducer (or gearmotor) use through holes or threads on the gear reducer housing feet as
stated in the fi gures below.
Avoid unbalanced lifting (during the movement, inclination must not exceed max ±15° as to mounting position) and, if necessary,
use additional belts to balance the weight.
Do not use any shaft ends.
Do not use motor eyebolts.
Do not use front threads of shaft ends or eventual external pipes.
Do not add supplementary loads to the gear reducer or gearmotor mass.
Attention!
During the lifting and handling:
•
do not stand under the suspended loads;
•
do not damage the gear reducer with an inadequate transport;
•
keep the gear reducers fi lled with oil in the mounting position foreseen in the order.
Gear reducers
Size ≤ iC 57...
Size ≥ iC 67...
UT.C 2427
UT.C 2428
UT.C 2429
UT.C 2430
UT.C 2431
UT.C 2432
UT.C 2433
UT.C 2434
Gearmotors
Belt to be used
exclusively
to ensure the motor, when directly mounted, against
oscillations due to transport;
not to be used for the lifting of entire gearmotor group.
Lifting point
4.1
Lifting and handling
12
UT.D 208-2021.12-EN
