13
96-0112 Rev W
July 2010
4. Connect the air line to the air in port on the solenoid. Connect the motor and
encoder cables.
5. Switches are labeled on the gearbox cover. Connect the TT status (clamp /
unclamp) cable and solenoid cable through the connector panel. Connect the
home switch to the home switch cable off of the motor encoder cable.
6. Connect the coolant line to the turret, using a reducer fitting at the cross
slide ball valve.
7. Reconnect shop air and set the machine regulator to 85 PSI.
8. Power on the machine.
9. Run the machine to maximum travel in the Z and X axes and check cable
travel.
Alignment
Squaring the TT-10 to the base:
1. Place mag base / indicator on the Z-axis rail on the operator side. Touch the
face of the turret at tool position 1 and jog the X axis. Squareness error should
not exceed 0.0004” over 10” of X-axis travel.
2. Tap the TT-10 into position to correct any error.
To spindle centerline:
1. Attach T-0028 (SL-40 BOT inspection tool holder) to tool position 1.
2. Install 15-2534 (spindle adapter plate) and a spindle alignment bar (T-1312
or T-1652).
3. Mount the indicator to the spindle alignment bar. Manually rotate the spindle
to sweep the inside diameter of the inspection tool and measure runout. It
should not exceed 0.001” for this tool position.
4. Repeat steps 1-3 with the inspection tool at position 4. TIR should not ex-
ceed 0.003” at this position.
