9
96-0112 Rev W
July 2010
Reinstallation
1. Clean the cross slide surface and set the TT-4 on the cross slide.
TL-2:
Install riser block between tool changer and cross slide.
2. Install shims and bolt tool changer to cross slide (4 bolts), but leave loose.
3. Connect control cables and air line. Install the motor cover.
Realignment
1. Put a magnetic base indicator on the spindle casting.
2. Place the tip of the indicator on the bottom inside surface of the tool turret in
the X direction.
3. Jog the X-axis and check the alignment of the tool changer along the entire
surface indicated.
4. Alignment error should not exceed 0.002” (0.051 mm) over 5.5” (140 mm)
travel.
Steps
1-4
Steps
5-7
5. Place the tip of the indicator on the bottom inside surface of the tool turret in
the Z direction.
6. Jog the Z-axis and check the alignment of the tool turret along the entire
surface indicated.
7. Alignment error should not exceed 0.002” (0.051 mm) over 5.5” (140 mm)
travel.
