Haas Automation VF Series, Control Book

Page: 57 / 127

50
January 2004
JOG KEYS
JOG KEYS: The jog keys are on the left below the function keys. These keys select which axes the
jog handle sends signals to and provide for continuous jogging. When a key is pressed
briefly, that axis is selected for use by the jogging handle. When a key is pressed and
held down, that axis is moved as long as the key is held down.
If a “ + ” key is pressed and held, the axis is moved so that the tool position is changed in a
positive direction relative to the work coordinates. If a “ - ” key is pressed and held, the axis
is moved so that the tool position is changed in a negative direction relative to the work
coordinates. The jog keys are locked out if the machine is running.
+A, -A Selects the A axis. Selects the B axis when used with the shift key and control
is configured with a fifth-axis option.
+Z, -Z Selects the Z axis.
+Y, -Y Selects the Y axis.
+X, -X Selects the X axis.
JOG LOCK When pressed prior to one of the above keys, the axis is moved in a continuous motion
without the need to hold the axis key depressed. Another press of the JOG LOCK key
stops jogging motion.
To the left side of the jog keys are three keys to control the optional chip auger. If the auger is enabled
with Parameter 209, these keys perform the following functions:
CHIP FWD Turns the auger in a direction that removes chips from the work cell.
CHIP STOP Stops auger movement.
CHIP REV Turns the chip auger in the reverse direction.
To the right side of the jog keys are three keys to control the optional automatic spigots. If the spigot
is enabled with Parameter 57, these keys perform the following functions:
CLNT UP Pressing this key positions the coolant stream direction one position higher, if possible.
CLNT DOWN Pressing this key positions the coolant stream direction one position lower, if possible.
AUX CLNT Pressing this key while in MDI mode will turn on the Through the Spindle Coolant system,
and pressing it again will shut off the system.