Haas Automation VF Series, Control Book, Page: 39 / 127

32
January 2004
RS-232 ERROR RS-232 error (shown in alarms).
SAFETY SWITCH The safety switch is not depressed; some functions not allowed.
SEL HI GEAR High gear selected in program.
SEL LOW GEAR Low gear selected in program.
SERVO IS OFF When servos are off , you cannot start a program.
SERVO IS ON! Parameter change was attempted with servo on. This is dangerous!
SHUTTLE IN Tool changer is in position for a tool change.
SHUTTLE NOT HOME The control is preventing the operator from zeroing the machine. Move the tool
shuttle to the “Standby Position”; this is the only safe place for the shuttle to be
when zeroing the machine.
SPEED COMD A spindle speed must be commanded.
SPINDLE IN USE Spindle is being controlled by program - manual controls not available
at this time.
SPINDLE LOCKED Spindle is locked in place.
SPINDLE ORI Spindle is being oriented.
SPINDLE STOP Spindle is not turning.
STRING TOO LONG The text being entered is too long.
SYSTEM ERROR Call your dealer.
TOOL CH LOCKED Tool changer has been disabled by parameter 57 bit 1.
TOOL OVERLOAD Cutting tool is overloaded.
WAIT OR RESET Cannot perform requested function until program finishes or RESET is pressed.
WAIT... Requested function is being performed.
WAITING... Waiting for RS-232 input.
WRONG MODE Function requested is available only in another mode.
And the following responses are received only in graphics mode:
CIRCULAR A circular motion is being performed.
COOLANT OFF Coolant pump is off.
COOLANT ON Coolant pump is on.
JOG COMD An axis jog has been commanded.
LINEAR A linear motion is being performed.
M30 FOUND End of program found and execution stopped.
NO ZOOM IN 3D Zoom is not allowed in 3D graphics mode.
RAPID A rapid motion is being performed.
RIGID TAP Rigid tapping is being performed.
SPINDLE CCW Spindle is turning counterclockwise.
SPINDLE CW Spindle is turning clockwise.
SPINDLE HIGH Spindle is in high gear.
SPINDLE LOW Spindle is in low gear.