Haas Automation VF Series, Control Book

Page: 37 / 127

30
January 2004
OVERWRITE xxxxxxxx.xxx (Y/N)?
Do you want to overwrite the file, yes or no ?
PAL DOOR HOLD Displayed during servo axis rotation, if the operator door or the pallet changer
access door is opened.
PLEASE WAIT Wait while control finishes processing edit command.
PROGRAM END The program being run has completed.
RAPID % Rapid override is active.
RUNNING When a program is running.
SEARCHING... Searching program for requested text or G code.
SENDING OFFSET Sending offsets via RS-232.
SENDING PARS Sending parameters via RS-232.
SENDING SETTING Sending settings via RS-232.
SENDING VARS Sending variables via RS-232.
SENDING... Floppy write or RS-232 output is in process.
SETTING 104 ON SETTING 104 and HANDLE CONTROL FEED RATE or HANDLE
CONTROL SPINDLE pressed.
SFTY HOLD The safety switch was released, and it has stopped the program.
SHIFT When the SHIFT key is pressed.
SINGBK SINGLE BLOCK is turned on.
SINGBK STOP When a program is stopped in SINGLE BLOCK.
SPIND nnn% Spindle speed override is active.
T UNCLAMPED The tool turret is unclamped.
TOOL CLAMP The tool is in the spindle.
TOOL UNCLAMP The tool has been unclamped.\
TOOL UNCLP Highlighted when the tool is unclamped.
TURRET IN The tool changer is in position for a tool change.
TURRET OUT The tool changer is out of position for a tool change.
XY-MANJOG Displays appropriate axis.
XYZA-MIR These axes are set to mirror image.
The following error messages are received when the wrong button is pressed.
ALARM ON Cannot start an operation until alarms are reset.
ALTER The selected text can now be altered.
AUX AXIS BUSY One or more auxiliary axes are busy in an operation.
BAD CODE Code entered is not understood.
BAD FILE NAME Not a valid file name.
BAD NAME Name entered is not Onnnnn.
BLOCK TOO LONG Block being edited would be too long.
CAN NOT COPY The selected program cannot be copied.
CAN’T RENAME The selected program cannot be renamed.
CAN’T UNDO! The last function cannot be undone.
CNVEYR DISABLED Chip conveyor has been disabled by parameters.
DIR FULL Maximum number of programs exceeded.
DIR NOT FOUND Directory of floppy disk not found.
DISK NOT IN DRV No disk in floppy disk drive.
DISK NOT READABLE Floppy disk cannot be read by control.
DISK WRT PROTECT Cannot save to floppy disk, it is write protected.
DISPLAYS OFF Indicates that M76 was used to turn off displays.
EMPTY PROG No program found between the % and %.
END OF PROG The program being run has completed.