20
Figure 23
Insert a transceiver module
2.
Identify the Rx and Tx ports on the transceiver module and plug the two LC connectors at one end
of the fibers into the Rx and Tx ports.
3.
Plug the LC connectors at the other end of the fiber into the Tx and Rx ports on a fiber port on the
peer device.
Figure 24
Connect fiber connectors
4.
After powering on the switch, check the SFP port LEDs.
For more information about the SFP LEDs, see the chapter “Appendix A Technical specifications.”
WARNING!
When you connect a fiber, note the following guidelines:
•
Never bend or curve a fiber with a fierce force. The bend radius of a fiber must be not
less than 10 cm (3.94 in).
•
Make sure the TX and RX ports on a transceiver module are correctly connected.
•
Keep the fiber end clean.
Installing/removing an interface card
NOTE:
The interface cards of the WX3024E are not hot swappable.