12
Connecting the power cord
WARNING!
To avoid damage to the equipment or even bodily injury, use the power cord shipped with the
device.
Before connecting the power cord, make sure the device and components are installed correctly.
To connect the power cord:
1.
Open the latch on the tie mount of the cable clamp and slide the clamp backward.
2.
Open the cable clamp, place the power cord through the opening in the cable clamp, and then
close the cable clamp.
3.
Insert the power cord connector into the receptacle on the power supply.
4.
Slide the cable clamp forward until it is flush against the edge of the power cord connector.
5.
Connect the other end of the power cord to the power supply system.
Figure2-21 Connecting the power cord
Removing the device from a rack
1.
Power down the device. For more information, see "
2.
Disconnect all cables from the device.
3.
Remove the device from the rack.
a.
Use a screwdriver to loosen the captive screws on the mounting brackets. Then, slide the
device out of the rack until it stops.
b.
Supporting the bottom of the device and holding down the release tabs on the inner slides,
pull the device all the way out of the rack.
