Installation Manual
H3C WA2200 Series WLAN Access Points
Chapter 4 Installation of Outdoor APs
4-18
Waterproof cover
Ethernet connector
Joint between connector and cable
Sealing nut
Figure 4-17
Insert the Ethernet cable connector into the Ethernet interface
4) First tighten the waterproof cover and then the sealing nut.
5) Use waterproof tape to wrap the joint between the waterproof cover and the cable.
III. Connecting an optical fiber
Caution:
Follow the steps below to connect a fiber cable. Otherwise, the AP may get damaged.
You need to configure an SFP module and a waterproof cover when connecting the AP
to an uplink device through a fiber cable, as shown in Figure 4-18.
Figure 4-18
Connect a fiber cable
