Operation Manual – Getting Started
H3C VG Series Voice Gateways
Chapter 2 Fundamental Configuration
2-8
Step 2:
Start Telnet client program on the workstation and set terminal emulation type
as VT100. See Figure 2-14 and Figure 2-15 (Telnet on Windows 9x).
Figure 2-14
Start Telnet program
Figure 2-15
Set up Telnet connection with the VG
Note:
In the above figure, the host name is the IP address of the WAN interface for remote
connection with the VG.
After you set up the Telnet connection successfully, the system will prompt you to enter
the username and password. If the authentication succeeds, the command line prompt
([VG], for example) appears. The message “Too many users or telnet permit!” means
that you cannot log onto the VG due to too many registered users. Telnet generally
supports five users at most.
Step 3:
Enter corresponding commands to configure the VG or view its running status.
You can also enter “?” for online help.
