H3C SR6608/6604 Routers Installation Manual
Chapter 1 Router Overview
1-34
Note:
You can refer to the table above when distinguishing between or preparing these
two types of Ethernet cables.
When preparing Ethernet cables, please follow the chromatogram given in the table
to arrange the wires. Otherwise communication quality will be affected even if the
equipment at two ends are connected.
When preparing Ethernet cables, use shielded cables preferentially for
electromagnetic compatibility (EMC).
VI. Fiber connecting 1000 Mbps optical Ethernet interface
You can use a single-mode or multimode optical fiber to connect a 1000 Mbps optical
Ethernet interface to an Ethernet. You can select proper fibers for the installed
1000Base-X SFP modules (GE SFP for short). Since the optical interfaces on these
SFP modules use LC optical connectors, you must use fibers with LC connectors. All
SFP modules are hot-swappable.
Note:
No SFP module is shipped with the device.
Use only the SFP modules provided by H3C. The device cannot recognize SFP
modules from other manufacturers.
For the connection of electrical Ethernet interfaces or optical Ethernet interfaces,
refer to section 5.10.4 “Connecting Ethernet Cables” in Chapter 5 “Installing the
Router”.
VII. Interface modules supported by FIP-100/FIP-200
HIMs supported by the device provide a bus processing capability of up to 10 Gbps,
which can meet the high-speed performance requirements of users. In addition, the
modular architecture allows the device to support a wide range of optional MIMs. The
interface module series provide abundant interfaces such as synchronous serial
interface, Ethernet interface, POS interface, and E1 interface.
For the interface modules supported by the device, see Table 1-12.
