4-12
5.
Install the access panel. For more information, see "
Installing a storage controller
Installing an M.2 SSD drive
CAUTION:
The M.2 SSD drives are not hot swappable.
IMPORTANT:
•
For system identification, use M.2 SSD drives recommended by H3C.
•
The M.2 SSD drive screw is shipped with the document bag for the chassis. Before installing an
M.2 SSD drive, keep the screw secure.
The device supports M.2 SSD drives with dimensions of 22 × 80 mm (0.87 × 3.15 in) and M.2 SSD
drives with dimensions of 22 × 60 mm (0.87 × 2.36 in). To install an M.2 SSD drive with dimensions of
22 × 60 mm (0.87 × 2.36 in), adjust the stud location in the system board. The following procedure
installs an M.2 SSD drive with dimensions of 22 × 80 mm (0.87 × 3.15 in).
To install an M.2 SSD drive:
1.
Wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably
grounded.
2.
Power off the device.
3.
Remove the access panel. For more information, see "
Installing a storage controller
4.
Insert the golden plating end of the M.2 SSD drive slowly into the M.2 slot at an angle.
5.
Slightly press the other end of the golden plating until the golden plating of the M.2 SSD drive is
in close contact with the connector in the M.2 slot.
6.
Use a Phillips screwdriver to screw the M.2 SSD drive into place.
Figure4-14 Installing an M.2 SSD drive
