undo irf
domain
View
em view
Default le
Paramete
Descripti
nd to restore the default.
ediate switch is in an IRF fabric,
u must assign this fabric a different domain ID than the LACP MAD-enabled fabric to avoid false
only when the switch operates in IRF mode. If you assign a domain ID for an
on, and then switch the operating mode of an IRF member switch to
standalone, this configuration loses effect even if you switch the operating mode of the switch to IRF
case, you need to re-assigned the domain ID as needed.
s
f the IRF fabric to 30.
<Sysname> system-view
ain 30
irf link
val
o irf link-delay
View
Parameters
Descripti
elay
command to set the delay time for the link layer to report a link-down event of an
IRF fabric.
Syst
vel
3: Manage level
rs
domain-id
: Specifies the domain ID assigned to an IRF fabric, ranging from 0 to 4294967295.
on
Use the
irf domain
command to assign a domain ID for an IRF fabric.
Use the
irf domain
comma
By default, the domain ID of an IRF fabric is 0.
You may deploy multiple IRF fabrics in one network for various networking applications. Domain IDs are
used to differentiate these IRF fabrics.
work that applies LACP MAD or ARP MAD detection, if the interm
In a net
yo
detection of IRF partition.
This command is available
IRF fabric, save the configurati
again. In this
Example
# Set the domain ID o
[Sysname] irf dom
-delay
Syntax
irf link-delay
inter
und
System view
Default level
3: Manage level
interval
: Delay time for the link layer to report a link-down event of an IRF fabric, ranging from 200 to
2000 milliseconds.
on
Use the
irf link-d
11
