Paramete
he range of 1 to 4.
Descripti
member ID for a member of an IRF fabric.
andalone mode. After it switches to the
f the switch
on file. If the switch has no member ID
.
changes to IRF. To set a member
e reboot of the switch.
renumber
command cancels the member ID set this time. After switch
boot, the member ID of the switch is
new-member-id
, and cannot be cancelled by the
undo
command.
IDs are used to identify switches and ports, and are also relevant to some
ember ID may cause switch configuration change or even loss.
irf member
.
Examples
f IRF member (the current member ID is 1) of an IRF fabric to 2.
ber 1 renumber
the switch number may result in configuration change or loss.
Continue?[Y/N]y
If you reboot the switch after you execute the
irf
member 1
renumber
2
command, the member ID of the
If you want to restore the member ID of the switch to 1, use the
undo irf member
2
figure a new member ID by using the
irf member
2
renumber
1
command.
rs
member-id
: Specifies the ID of an IRF member switch, which is in the range of 1 to 4.
new-member-id
: Specifies the new ID of the member of the IRF fabric, which is in t
on
Use the
irf member renumber
command to set a
Use the
undo irf member renumber
command to remove the configuration.
If the switch supports pre-configuration, it has no default ID in st
IRF mode, it uses the member ID pre-configured in standalone mode by default.
If the switch does not support pre-configuration, its member ID defaults to 1.
The member ID functions in the following ways:
•
When the operating mode of the switch changes from standalone to IRF, member ID o
is needed for the auto-conversion of the configurati
configured, use this command to set a member ID for it
•
An IRF fabric uses member IDs to uniquely identify and manage member switches. To set a
member ID for the switch when it operates in standalone mode, use the
irf member
command, and
the member ID takes effect when the operating mode of the switch
ID for the switch when it operates in IRF mode, use the
irf member
member-id
renumber
new-member-id
command, and the member ID takes effect when the switch reboots.
The above setting takes effect at th
Execution of the
undo irf member
re
To change the
new-member-id
, set another member ID for the switch.
For an IRF fabric, member
command lines. Therefore, modifying a m
Modify member IDs with caution.
Related commands:
# Set the member ID o
<Sysname> system-view
[Sysname] irf member 1 renumber 2
Warning: Renumbering the switch number may result in configuration change or loss.
Continue?[Y/N]y
To cancel the above configuration and restore the original member ID of the switch, execute the
following command:
[Sysname] undo irf mem
Warning: Renumbering
switch changes to 2.
renumber
command, or con
17