mad enable
e
o mad enable
View
Default level
Paramete
Descripti
se the
mad enable
command to enable LACP MAD to detect the IRF fabric for multi-active collisions.
isabled.
nd dynamic aggregate interfaces, but it takes effect
command, you are required to input the IRF domain ID to avoid the
kets of this IRF fabric are sent to a neighbor IRF fabric.
Examples
nabled Layer 3 dynamic aggregate interface 1.
[Sysname] interface route-aggregation 1
The assigned domain ID is: 1
ACP only enable on dynamic aggregation interface.
lude interface
undo mad
exclude interface
interface-type interface-number
Syntax
mad enabl
und
Aggregate interface view
3: Manage level
rs
None
on
U
Use the
undo mad enable
command to disable LACP MAD.
By default, LACP MAD is d
This command can be configured on both static a
only on dynamic aggregate interfaces because of LACP.
When executing the
mad enable
situation that the MAD detection pac
# Enable LACP MAD on LACP-enabled Layer 2 dynamic aggregate interface 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned domain ID is: 1
Info: MAD LACP only enable on dynamic aggregation interface.
# Enable LACP MAD on LACP-e
<Sysname> system-view
[Sysname-Route-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
Info: MAD L
mad exc
Syntax
mad
exclude
interface
interface-type interface-number
24