4-35
NOTE:
USB devices from different vendors vary in compatibilities and drivers. H3C does not guarantee the
correct operation of USB devices from all vendors on the switch. If a USB device fails to operate on
the switch, replace it with one from another vendor.
10/100/1000BASE-T autosensing Ethernet port
Table4-3 10/100/1000BASE-T autosensing Ethernet port specifications
Item
Specification
Connector type
RJ-45
Interface attributes
•
10 Mbps, full duplex
•
100 Mbps, full duplex
•
1000 Mbps, full duplex
•
MDI/MDI-X, auto-sensing
Max transmission distance
100 m (328.08 ft)
Transmission medium
Category-5 (or above) twisted pair cable
Standards
IEEE 802.3i, 802.3u, 802.3ab
SFP port
CAUTION:
Make sure the ambient temperature for an operating S5560S-28F-EI does not exceed 40°C (104°F)
if the following conditions exist:
•
The switch uses one or two PSR75-12A power supplies for power supply.
•
The switch uses transceiver modules with a maximum transmission distance greater than or
equal to 80 km (49.71 miles).
CAUTION:
Make sure the ambient temperature for an operating S5560S-52F-EI does not exceed 40°C (104°F)
if the following conditions exist:
•
The switch uses one or two PSR75-12A power supplies for power supply.
•
The switch uses transceiver modules.
The following switches provide fixed SFP ports on the front panel. You can install the FE SFP
modules in
or GE SFP transceiver modules and cables in
•
S5560S-28F-EI
•
S5560S-52F-EI
•
S5560S-28S-EI
•
S5560S-28P-EI
•
S5560S-52P-EI
•
S5560S-28S-PWR-EI
•
S5130S-28S-HI
•
S5130S-28S-PWR-HI
•
S5130S-28C-HI
