2-26
Installing and removing an expansion module
CAUTION:
•
Do not touch any components on the expansion module.
•
Do not use excessive force when installing or removing the expansion module.
•
If you are not to install an expansion module after removal, install a filler panel over the empty slot
to ensure good ventilation.
•
Do not install or remove the expansion module during switch startup.
The S5130S-28C-HI, S5130S-52C-HI, S5130S-28C-PWR-HI, and S5130S-52C-PWR-HI switches
each provide an expansion slot at the rear panel. You can install an LSWM2SP2PB interface module
in the slot. For more information about the interface module, see expansion modules in
Hardware
Information and Specifications
.
Installing an expansion module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Use a Phillips screwdriver to remove the screw that secures the filler panel, and then use a
flat-blade screwdriver to pry open the filler panel and remove it.
IMPORTANT:
Keep the removed filler panel for future use.
Figure 2-31 Removing the filler panel
3.
Take the expansion module out of the package, and then install the expansion module as
shown in
a.
Open the ejector lever on the expansion module, as shown by callout 1.
b.
Slide the expansion module into the slot along the guide rails until you cannot push it further,
as shown by callout 2.
c.
Close the ejector lever on the expansion module, as shown by callout 3.
2
1