Operation Manual – QoS
H3C S5500-EI Series Ethernet Switches
Chapter 3 QoS Policy Configuration
3-5
Note:
Suppose the logical relationship between classification rules is
and
. Note the following
when using the
if-match
command to define matching rules.
z
If multiple matching rules with the
acl
or
acl ipv6
keyword specified are defined in a
class, the actual logical relationship between these rules is
or
when the policy is
applied.
z
If multiple matching rules with the
customer-vlan-id
or
service-vlan-id
keyword
specified are defined in a class, the actual logical relationship between these rules is
or
.
II. Configuration example
1) Network
requirements
Configure a class named test to match the packets with their IP precedence being 6.
2) Configuration
procedure
# Enter system view.
<Sysname> system-view
# Create the class. (This operation leads you to class view.)
[Sysname] traffic classifier test
# Define the classification rule.
[Sysname-classifier-test] if-match ip-precedence 6
3.4.3 Defining a Traffic Behavior
To define a traffic behavior, you need to create a traffic behavior and then configure
attributes for it in traffic behavior view.
I. Configuration procedure
Follow these steps to define a traffic behavior:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a traffic behavior
and enter the
corresponding traffic
behavior view
traffic behavior behavior-name
Required
behavior-name
:
Behavior name.
This operation
leads you to traffic
behavior view
