H3C S5120-EI Series, Operation Manual

Page: 64 / 1191

1-13
Currently, when you configure the global link-aggregation load sharing criterion or criteria, the switch
supports the following criteria:
z
Use a source IP address alone.
z
Use a destination IP address alone.
z
Use a source MAC address alone.
z
Use a destination MAC address alone.
z
Combine a source IP address and a destination IP address.
z
Combine a source IP address and a source port number.
z
Combine a destination IP address and a destination port number.
z
Combine any two or all three of the following elements: ingress port number, source MAC address,
and destination MAC address.
Configuring group-specific load sharing criteria
Follow these steps to configure load sharing criteria for a link aggregation group:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter aggregate interface
view
interface bridge-aggregation
interface-number
—
Configure the load
sharing criteria for the
aggregation group
link-aggregation load-sharing
mode
{
destination-ip
|
destination-mac
|
source-ip
|
source-mac
} *
Required
By default, the load sharing
criteria of an aggregation group
are the global link-aggregation
load sharing criteria.
Currently, when you configure the load sharing criterion or criteria for a link aggregation group, the
switch supports the following criteria:
z
Use a source IP address alone.
z
Use a destination IP address alone.
z
Use a source MAC address alone.
z
Use or a destination MAC address alone.
z
Combine a source IP address and a destination IP address.
z
Combine a destination MAC address and a source MAC address.