25
To install a filler panel in a switching fabric module slot:
1.
Loosen the captive screws on the ejector levers and rotate outward the ejector levers.
2.
Orient the filler panel with the side marked "Up" facing up. Hold the filler panel front panel near
the ejector levers with one hand and support its bottom with the other. Place the filler panel
bottom gently on the bottom guide rails of the chassis. Align the filler panel with the switching
fabric module slot. Push the filler panel slowly into the slot along the guide rails. See callout 1
in
Keep the filler panel parallel to the switching fabric module slot to avoid touching other
components in the chassis.
3.
As shown by callout 2 in
, continue to push the filler panel until the brakes on its
ejector levers touch the slot edges tightly. Simultaneously rotate the ejector levers inward.
4.
Fasten the captive screws on the ejector levers.
Figure 23 Installing a filler panel in a switching fabric module slot (S12516X-AF switch)
(1) Push the filler panel slowly into the slot
(2) Simultaneously rotate the ejector levers inward
(3) Fasten the captive screws on the ejector levers
Removing a filler panel from a switching fabric module slot
1.
As shown by callout 1 in
, loosen the captive screws on the ejector levers.
2.
As shown by callout 2 in
, rotate outward the ejector levers. Then pull the filler panel
part way out of the slot.
3.
As shown by callout 3 in
, hold the filler panel by the top and bottom edges to pull the
filler panel out of the slot.
Keep the removed the filler panel secure for future use.
