28
port hybrid pvid
Use
port hybrid pvid
to configure the PVID of the hybrid port.
Use
undo port hybrid pvid
to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id
: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
The following matrix shows the command and hardware compatibility in Layer 2 aggregate interface
view:
Hardware Command
compatibility
MSR800 Yes
MSR 900
No
MSR900-E Yes
MSR 930
Yes
MSR 20-1X
No
MSR 20
No
MSR 30
Yes
MSR 50
Yes
MSR 2600
Yes
MSR3600-51F Yes
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the
undo vlan
command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
H3C recommends that you set the same PVID for the local and remote hybrid ports.
You must use the
port hybrid vlan
command to configure the hybrid port to permit the packets from
the PVID to pass through.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
•
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
