Interface Card and Interface Module Manual
H3C MSR 20/30/50 Series Routers
Chapter 3 Multifunctional Interface Modules
3-5
Figure 3-6
MIM-2GBE
The following table describes the LEDs on the MIM-1GBE/MIM-2GBE panel.
Table 3-4
Description of the LEDs on the MIM-1GBE/MIM-2GBE panel
LED
Description
LINK
OFF means no link is present; ON means a link is present.
ACT
OFF means no data is being transmitted or received; blinking
means data is being received or/and transmitted.
3.2.4 Interface Cable
MIM-1GBE/MIM-2GBE uses both crossover and straight-through cables for
connection.
Figure 3-7
Ethernet cable
For the pinouts of Ethernet cables, see
Low-End and Mid-Range Series Routers Cable
Manual
.
3.2.5 Connecting the Interface Cable
To connect a PC or another router, use a crossover cable; to connect a LAN Switch or
HUB, use a straight-through cable.
Step 1: Connect one end of the cable to the Ethernet port and the other end to the peer
device;
Step 2: Check the status of LINK LED on the 1GBE panel: ON means the link is
connected and OFF means the link is not connected. In the latter case, check the line.