1
9
. At this point add the horizontal stabilizer seat A12 to
the rear of former A11.
20
. Using a PVA or similar glue
,
attach the two balsa fuselage sides to the frame, use dress
making
pins
or glass/plastic headed pins
to hold them in place as the glue dries.
22
. Cover the
bottom
of the
rear
fuselage with the
balsa
sheet parts A3
0
. Once again use a good PVA
glue and
pins to hold them in place as the glue dries.
21
. Install the 2 plastic push rod outer tubes into the fuselage as shown. They run from the radio
compartment
under the wing and exit
on either side of the fuselage
at the rear just under the horizontal stabilizer seat
as
shown above.
18.
When these have set add the center bottom
6x6mm balsa strip from former A7 and shape it to fit
in between the 2 outer strips as shown below.
23. Fill in the rear of the fuselage with scrap
balsa as shown. Width of the fuselage at the
rear should match the stern post part D3,
sand as necessary.
Page 7
