1
4
. Laminate together the 2 off wing fixing plates
A19, when dry
i
nstall the four-
pronged blind nut as
shown.
1
5
. Glue the prepared wing fixing plate A19 to the top
former A8. Then add the 2 off
wing seating strips A18.
1
6
. Glue the 3 off 6
x
6mm balsa strips to the top of
the fuselage from
the
rear wing seat
former A8
down to the rearmost former A11. Glue these also to
formers A9 and A10.
1
7
.
Then
add the 2 off 6x6mm balsa strips to the
bottom of the fuselage from former
A7. These will
require shaping at the rear as shown b
elow
then glued
together
(Please note these
do not go to a point, the
fuselage at the rear needs to be the same width as the
rear of part
A12)
.
When these have
set add the center
bottom 6x6mm balsa strip from former A7 and shape
it to fit
in between the 2
outer strips as shown below.
Be careful at this point not to build a twist into
the
fuselage
assembly.
Page 6
