5
7
. Glue into place the 2 off 8mm dowels
to the front of the wing as shown above.
5
8
. Carefully measure and mark the position
of the wing trailing mounting bolt. Drill a 3mm
hole then test fit the wing to the fuselage and
screwing in the supplied 3mm wing bolt.
5
6
.
When the glue has set on the dihedral brace in the
first wing you are now ready to join the wings. Slide
the second wing onto the brace and check the wing
roots meet each other with a good joint, if not adjust/
sand as necessary. Also check that the wings are
perfectly aligned with each other with no twists.
When satisfied with the fit and alignment apply glue
to the wing roots and the brace and bring the 2
together. Wipe of any excess glue that squeezes out
and support the wings at each wing tip to achieve the
correct dihedral angle as the glue dries.
5
5
.
Glue the 2 off B25 plywood parts together to form
the
wing dihedral brace.
Before you join the wings t
est fit
each
one
onto the fuselage
, adjust as necessary
. Trim the
roots of each wing next to the spars to ensure the
plywood dihedral brace fits snugly into each root
up to
the center of the brace
. When happy with the fit glue the
brace
up to the center line
into one wing only
leaving the
same amount sticking out.
Page 14
