e
H•KING
•
Once satisfied with the tails fit, locate the two foam tail retaining pegs. One is bigger than
the other, the bigger one going in the forward hole and the smaller into the rear on the
bottom side of the fuselage (A). Note also the ends of these are angled to match the profile
of the fuselage so dry fit first to confirm correct orientation (B), then pull out, apply a small
amount of foam contact glue and install once more ensuring the base of the pegs are flush
with the bottom of the fuselage (C).
NOTE: If you have trouble pushing both foam pegs in, gently wiggle the horizontal stab until the
corresponding holes in the tail align with the fuselage. With the pegs pushed into the fuselage
fully, this should lock the the stablilizer in place without any issue.