H•KING
i
Receiver Installation:
0
Use the supplied self adhesive velcro to secure
the 4-6ch receiver (Rx) of your choice in the
approximate location in the fuselage as shown
(A). Connect the ESC (throttle), aileron, elevator
and rudder servos to the corresponding
channels of your Rx as stated in the manual
supplied with it (B). Use clear tape to secure any
excess servo leads or Rx aerials if you wish at
this point. With your Rx installed you can now
move onto the final stage of the electronics set-
up.)
i
Final servo adjustments and set-up:
WARNING: FOR SAFETY REASONS NEVER ATTEMPT
TO
POWER UP AND SET-UP YOUR
MODEL WITH THE PROPELLER ATTACHED. COMPLETE ALL ELECTRONIC SET-UP WITHOUT
THE PROPELLER INSTALLED, FAILURE
TO
DO
SO
COULD RESULT IN DAMAGE
TO
YOURSELF,
THE MODEL AND PROPERTY.
0
0
With your transmitter (Tx) turned on and bound to your receiver, connect your flight battery the ESC
supplied. The model is now powered and you should have control of the servos. You can now center
all control surfaces and confirm they are moving in the correct direction. To mechanically center the
control surfaces first ensure your trims are neutral on your radio and back on the model the servo
horns are 90 degrees to the push rod (A). Loosen the screw on the push rod quick connector to allow
the control surface to move freely (A). Now place the control surface so they are neutral and level
and once confirmed, tighten the screw of the push rod quick connector firmly (B) .. )
i
Proppeller and Spinner installation:
NOTE: It is highly reccomended to balance both the prop and the spinner before flight. This will result
in less vibration and wear to the airframe and a more efficient set-up in flight
0
Locate the prop, spinner and complete prop adaptor as shown (A). First slide the prop
adaptor onto the motor shaft followed by the spinner back plate then place the prop onto the
prop shaft and tighten with the remaining washer and prop nut as shown (B). Be sure to position
the rear edge of the prop just ahead of the small plastic vertical pegs. This will ensure the spinner
fits correctly over the prop.
