P-51 'GALLOPING GHOST'
H-KING'S 1016MM SPAN, PLUG & FLY SPORTS-SCALE HOT ROD!
0
You can now connect the push rod to
the elevator control horn by
removing the plastic rod keeper,
inserting the push rod end into the top
hole of the horn and clipping it back
into place on the pushrod to secure it
to the control horn as shown.
i
Wing Installation:
0
Lift the canopy hatch by pulling up the plastic tape at the rear (A). Now feed through the
aileron Y-lead into the fuselage as shown (B), position the wing onto the fuselage by
pushing the wing pegs on the leading edge into the wing peg slots on the fuselage (C) and
finally secure the wing in place using the supplied 4mm x 50mm wing bolt as shown (D)
Note: Be sure not to over tighten the wing bolt, it should not be
so
tight that it deforms the foam
of the fuselage around the plastic wing bolt washer. If the wing is still a little loose for your liking
you can either apply a small amount of contact foam glue or
some
double sided tape to the wing
where it
meets
the fuselage for added security if desired.
