44
Operating manual
ARCPULL 350
Translation of the original
instructions
Cause
Remedy
1
st
case: weld on flat plate
2
nd
case welding on sheet
metal with metal obstacle
3
th
weld on IPN
6. INSTALLING ACCESSORIES AND ADJUSTING THE GUN
The fitting of accessories and their adjustment on the gun must be done:
- gun connected to the generator
- product switched on
- gun initialization phase completed (request to press the trigger)
Appui gachette
6.1. CHANGING AND ADJUSTING THE LENGTH OF THE GROUND RODS (059627)
Note 1: It is necessary to replace the ground clamp rods if they have excessive markings at their ends, or if they have
been bent following a fall from the gun.
Note 2: The use of the ArcPull Rivet Box 1 and 2 rivet extraction boxes (Ref 064584 and 064584), as well as the Diffi
-
cult Access box (Ref 070813), require the use of the short rods provided in the ArcPull350 package.
Loosen the locking wheel (n°3 in figure 2) so that
the earth clamp rods (n°4 in figure 2) protrude as far
as possible from the gun.
Then retighten the locking knob.
