54
Operating manual
ARCPULL 350
Translation of the original
instructions
On the Synergic Mode main screen are displayed:
1 - The material of the insert: AlMg, Fe, etc.
2 - The type of bath protection: No Gas, Ferrule, or the type of gas recommended
3 - The pictogram of the piece to be welded
4 - The thickness of the sheet on which the part will be welded
5 - "Prog" followed by the number is displayed in the case of a saved welding configuration (see §8.4.3).
6 – A message zone specifying the state the product is in (see § 8.3)
zone de
message
FeCu Prog 3
ArCo_8%
M8
4.0
zone de
message
1
2
4
6
3
5
8.1.1. TYPE OF PART TO BE WELDED
From the synergy displayed on the screen, defined by a type of part (3), its material (1) and its protection (2), it is pos
-
sible to modify only the size of the part (M
4
, M
5, etc.) by pressing G and G- without having to go through the settings
menu (see §
8.4.1).
Added part
Pictograms
Comments
Pulling ring
Pressing G and G- cycles through all ring synergies contained in the station.
Material (1) and gas protection (2) are dynamically updated.
Rivet Extractor
Rod
When a rivet extraction rod synergy is chosen, the thickness display (4)
changes automatically and corresponds to the diameter in millimeters of the
rivet head to be extracted.
Internally
Threaded Stud
Synergies associated with US type short-time internal thread studs.
The Mx value corresponds to the internal thread of the stud.
Stud (and pawn)
Associated synergies:
• Low carbon steel (Fe) and stainless steel: DD type threaded stud
• Copper-plated steel (FeCu): PS-type short-time threaded stud
US type short time pawn
insulation nail