EN
59
Operating manual
ARCPULL 700
Translation of the original
instructions
10.3. TIMELINE
10.3.1. POWER-UP INITIALISATION
When it is controlled by a PLC, the product’s start-up requires that:
- no consumables are fitted to the gun
- no mechanical stress should be exerted on the gun’s electrode holder drive shaft
The PLC can be activated before or after the product is switched on.
Once the product has been switched on, the equipment’s electronic system must be switched on for five seconds
before the gun can be switched on.
Powering up
ACTIVE
CONNECT
TRIGGER
READY
400 VAC
duration ≥ 5 s
0 V
0 V
24 V
Activating the PLC control can be done before powering up
Powering up the product
Activate the trigger to
initialise the product
Gun initialisation
Machine ready to weld