Guzzanti GZ 116, Instruction Book

Page: 330 / 353

24
How to sew
Ьuttonholes
Preparation:
Remove the zigzag foot and attach the buttonhole foot. Adjust
the stitch length dial between "0.5" - "1". The density of the stitch
depends on thickness of the fabric.
Note:
Always test sew a buttonhole.
To prepare the faЬric:
Мeasure the diameter of the button and add 0.3cm (1/8") for the
bartacks. lf you have a very thick button, add more to the
diameter measurement. Мark the position and length of the
buttonhole on the fabric.
Position the fabric so that the needle is on the mark that is
furthest from you.
Pull the buttonhole foot towards you as far as it will go.
Lower the foot.
a. Turn the pattern selector dial to . Sew at moderate speed
until you reach the end mark.
b. Turn the pattern selector dial to and sew 5-6 bartack stitches.
c. Turn the pattern selector dial to and sew the left side of the
buttonhole to the mark at the end which is further from you.
d. Turn the pattern selector dial to and sew bar tack stitches.
Remove the fabric from under the foot. Draw the upper thread
through the backside of the fabric and knot upper and lower
threads. Cut the center of the buttonhole with the seam ripper,
being careful not to cut the stitches on either side.
Tips:
- Slightly reduce upper thread tension to produce better results.
- Use backing material for fine and stretchy fabrics.
- lt is advisable to use a gimp cord for stretch or knit fabrics. The
zigzag should sew over the gimp. (e)
a b c d
e