EN
30
4
5
6
1
2
3
int
Remote Control
ON/OFF (1)
To switch on, press the field with the
ON/OFF symbol. The fan runs at the 1.
level. To switch off, press the ON/OFF
symbol again.
Increasing fan power (2)
Press the symbol
Increase fan power.
The fan power is increased by one level
each time the field is pressed.
Reducing fan power (3)
Press the symbol
Reduce fan power.
The fan power is reduced by one level
each time the field is pressed until level
1 is reached.
Lighting (4)
Press the button with the lighting symbol
to switch on the lighting. The lighting is
switched off by pressing the button
again. The lighting is dimmed by press-
ing and holding the lighting symbol.
Intensive level (5)
Maximum fan power is reached by
pressing the button
Intensive level.
The
fan power switches back by one level
after 5 minutes.
Automatic follow
-
up time (6)
The automatic follow
-
up time is activat-
ed by pressing the field with the
Follow
-
up time
symbol. The follow
-
up time sym-
bol (LED) lights up. The cooker hood
continues to run for approx. 15 minutes
and gradually switches back one step
every 5 minutes (from the last step set)
before it finally switches off.
Filter saturation (f): (1)
After 15 operating hours, the red grease
filter saturation indicator (in the control
unit) flashes . The grease filter must be
cleaned. After cleaning the filter, hold
down the (1)~ 15 sec. key until the red
indicator light goes out.
( The unit must be
in ON mode
-
TW function is deactivated
when the red LED flashes ! )
Colour temperature setting
( depending on the variant )
The colour temperature of the LED
lighting can be infinitely adjusted
between 2700K and 6500K.
Press and hold the delay button
(6)
to
adjust, the LEDs start to change the
colour temperature. When the desired
setting is reached, release the button,
the colour setting is saved.
Changing the batteries:
The battery cover is located on the back
of the remote control. Unscrew the Phil-
lips screw and lift it with thumb and in-
dex finger until the magnetic contact
which holds the battery cover is re-
leased. Now remove the empty batteries
and replace them with the same type.
Replace the battery cover and screw it
tight. Attention: Dispose of empty batter-
ies properly !
Technical data
Dimensions: 230 x 34 x 10
Battery: 2 lithium batteries CR 2032 3 V
Infrared range: ~ 2 m
Filter Saturation
Button min. 10 sec.
pressures to a
red
LED
turns off !
