KVM over IP
Chain rule
The
Chain rule
determines whether the access from the hosts is allowed or not. It can be
one of these two values:
ACCEPT : access allowed
DROP : access not allowed
The rule can be configured to apply to a particular Group level (All, User, Super,
Administrator).
When the IP-KVM receives a TCP packet, it will process the packet with the chain rule
depicted below. The process ordering is important; The packet will enter the chain rule 1
first, if meet the rule then take action directly, otherwise go to chain rule 2.
Figure 5-21 Chain Rules of IP Filtering
Check the “Enable Group based System Access Control” to edit the rules
Users can add a new IP filtering rule by setting the properties at adding line by
Append
or
Insert
. User can remove a rule by
Remove
or
Delete
.
93 / 132
Summary of Contents for IPK-101
