PX Control Panel User Manual – Issue C
- 18
-
Automatic Setting
The system may have been programmed by the installation engineer to automatically set all or parts of
the system according to a pre-programmed schedule. The schedule will have been programmed to take
into account the normal closing time, non-working days and holidays. The schedule may be configured
for any set mode.
Aborting The Setting Procedure
The setting procedure can be aborted at any time during the exit time by pressing
7
on the keypad that
was used to start setting, logging on to any other keypad or turning a keyswitch to the unset position.
Setting
Stopped
If setting is aborted by logging onto a keypad the setting aborted message
will be displayed.
Setting with Warnings
The system will automatically display any conditions which the user should be aware of before setting
the system. These conditions are described as set warnings and do not prohibit the user from setting
the system in the normal way. The user however may wish to change a condition before setting the
area(s) or system, where appropriate.
When a user selects set, and warnings exist, the set warning prompt will be displayed.
Set Warning
4
=Report
Press the
4
button to display the setting warning(s).
Loading Door
Isolated
The display will automatically scroll through the list of warnings
Workshop
4
=Set
Press
4
to proceed with setting or press
7
to cancel setting
The set warnings include:
1. Bypassed circuits
2. Circuits On Soak (a special circuit test mode set up by the installation engineer)
3. Isolated circuits
4. Line Fault (only when setting with telephone line fault is allowed)
Setting Faults
The system will not permit setting with faults or with any circuit open or activated, with the exception of
exit route circuits or circuits which have been bypassed or isolated.
When a user selects set, and faults exist, the set warning prompt will be displayed.
Cannot Set
Tamper
Rear Door
The display will automatically scroll through the list of faults
The system may have been programmed to allow the user to force set if circuit faults exist.
Intelligent Security & Fire Ltd
