Procedure
1. Loosen the bolts (B) (5x).
2. Adjust the position of the counter
blade (A).
3. Make sure that the gap (C) is between
0.5 and 1 mm.
4. Tighten the bolts (B).
5. Check the gap again. If necessary,
repeat steps 1 to 4.
6. If the gap (C) is correct, tighten the
bolts (B). Apply a torque of 50 Nm.
7. Repeat the procedure for the second
blade.
7.1.7
Finish
Procedure
1. Remove the locking bolt.
2. Install the plug.
3. Install the input. Refer to section
.
4. Install the output. Refer to section
.
7.2
Do maintenance on the engine
1. Do maintenance on the engine. Refer to the OEM documentation of the specific
engine of your machine.
7.3
Remove a blockage
Warning:
•
Never use your hands to remove wood chips between the blades. Always
use a branch or tool.
•
Do not touch the blades. The blades are very sharp and could cause
serious injuries.
Procedure
1. Follow the procedures in this section in the given sequence to remove a blockage.
7.3.1
Do a visual check
Procedure
1. Do a visual check for large objects in the input or output.
2. If you see large objects, remove them.
7.3.2
Remove the output
Preliminary requirements
•
Wrench size13
A
C
A
B
Corrective maintenance
D09-CC13S20-11
39
