Procedure
1. Remove the bolts (A) and the
washers (B).
2. Start the machine and let it run idle.
Refer to
.
3. Do not put any material in the input.
4. Tilt the input (C) until the locking key
is removed from the safety lock switch
(D).
Caution:
Make sure that the
machine fully stops.
5. The test is successful if the machine
stops.
6. Tilt the input back.
7. Install the bolts and the washers.
6.5
Clean the machine
Caution:
Do not clean the machine with a high-pressure cleaner.
Procedure
1. Remove wood chips and dust from the machine. Use a soft brush.
6.6
Do a check of the tension of the belts
Preliminary requirements
•
Wrench size 10
•
Alignment ruler
B
A
C
D
Preventive maintenance
D09-CC13S20-11
29
