5.3
Change the output
Change to the high output
1. Remove the low output. Refer to section
.
2. Position the cover plate of the low
output (A) on the shredderbox.
3. Make sure that te locking key (B)
correctly fits in the safety lock switch
(C)
4. Install the bolts (D).
5. Install the high output. Refer to
section
Change to the low output
1. Remove the high output. Refer to
section
.
2. Move the hinges (A) of the cover plate
(B) into the holes (C).
3. Tilt the cover plate.
4. Make sure that the locking key (D)
correctly fits in the safety lock switch
(E).
5. Install the bolts (F) and the washers
(G).
6. Install the low output. Refer to section
5.4
Start the machine
Preliminary requirements
1.
The panic bar is in the upper position.
2.
The input and the output are installed.
3.
The deflector is set to the required position.
Warning:
Only start the machine when the input and shredderbox are empty.
D
B
C
A
E
D
2
3
A
C
B
F G
Instructions for use
24
D09-CC13S20-11
