GSI Group 890-00584, Installation And Configuration Manual

Page: 85 / 120

Chapter 12: Configuring an Intrusion Zone
Providing Enough Time to Exit After Arming
Once you have armed your system, you must have enough time to exit the building without setting off an
alert.
Before You Begin
Attention
Only the entry zones can have an Exit delay . You must click on the Entry zone button to make the zone
an entry zone to have access to the field.
What You Should Know
NOTE: Only zones configured as intrusion type zones can be armed.
1. In edit mode, under the General tab, click in the edit field next to the Exit delay .
2. Enter the time needed to exit the building after arming.
Activating the at Home Arming
When your building is equipped with motion detectors, and you would like to arm the windows and doors,
you can activate the at home arming.
In edit mode, under the General tab, click on the at home arming button.
The green LED lights when the at home arming is enabled.
Activating the Chime on an Intrusion Zone Type
In edit mode, under the General tab, click on the box next to the chime icon.
A checkmark indicates that the chime is enabled.
Activating a device in the Event of an Alert or Trouble
A device, such as a fan or a heater, can be turned on or off when an alert condition or trouble is detected in
a zone. To do so, a programmable output must be activated in the zone.
1. In edit mode, under the Action tab, click on the edit field next to the event type you want the device’s
output linked to.
A list of available outputs is displayed.
NOTE: Only the previously configured outputs are displayed.
2. Click in the box to the left of the chosen output.
Receiving a Phone Call When an Alert is Active
In the event of an alert in a zone, the system calls the phone numbers selected to inform key people of the
alert state.
What You Should Know
895-00677 Agri Alert 128 Touch 85