GSI Group 890-00584, Installation And Configuration Manual

Page: 80 / 120

Chapter 11: Configuring a Dry Contact Zone
In edit mode, under the Action tab of the zone you are configuring, click on the edit field next to siren
icon .
A check mark indicates the siren is enabled.
Enabling the Internal Speaker
The internal speaker allows you to hear the alert messages from the system when you are near the main
system.
In edit mode, under the Action tab of the zone you are configuring, click on the edit field next to the
speaker icon .
A check mark indicates the internal speaker is enabled.
Recording the Zone Audio Label
The audio label is the name the system repeats to identify the zone when calling because an alert is set off
in the zone.
1. In edit mode, under the Mess. tab of the zone you are configuring, click on the record icon .
NOTE: The time remaining to record the audio label starts counting down once you press the record
button.
Tip
For consistency, use the same words as you used when giving the Name in the zone’s General tab.
2. State the zone audio label clearly.
NOTE: The recording stops when it has reached the allowed time of 8 seconds.
3. Click on the play icon to listen to the recording.
4. If the recording is not satisfactory, press the garbage icon to delete the recording and start over.
5. Repeat steps 2 through 5 to record the zone audio label in another language.
Viewing Zone Calibration
In addition to system diagnostics, you can view the zone calibration in the zone itself.
In status mode, under the Message tab, click on the Calibration button.
Trouble limits, raw and calibrated data is displayed.
The green LED lights when the Calibration button is enabled
80 895-00677 Agri Alert 128 Touch