Antenna Setting Menu allows to correspond the
following parameters to the antenna number:
– LNB type
– DiSEqC input
– 22 KHz Tone
– LNB power
– Motorized system
Using the red button on the Remote
Control you can completely delete data of the
antenna with its services.
To add a new antenna choose in the list of anten-
nas “New” and press the yellow button,
and after that enter new antenna parameters.
It is possible to connect 4 antennas to the STB, using DiSEqC 1.0, and 8 antennas, using “22
KHz” switch.
LNB TYPE
Select LNB type (single, dual, universal1, universal 2).
Single LNB low frequency can be 5150, 9750, 10600, 10750, 11475MHz.If the required LNB
Frequency is not available, then enter the frequency manually using the Numeric buttons (0~9).
Dual LNB low and high frequency can be 5150, 9750, 10600, 10750, 11475MHz.If the re-
quired LNB Frequency is not available, then enter the frequency manually using the Numeric
buttons (0~9).
When you select Universal 1 it switches between 9750 and 10600MHz automatically. The
“22KHz Tone” setting is unnecessary. (Disabled)
22KHZ TONE
Used for two or more antennas or LNBs.
DiSEqC INPUT
If you use several antennas or LNBs, connected to the STB with DiSEqC switch, in this item
you have to select parameters for DiSEqC A-D (1-4) or TonBurst A B.
For correct operating with multiswitch system, supporting DiSEqC 2.0, or analogue operating
(0/22 KHz, 13/18 volt, tone impuls) it is imperative:
– Either give DiSEqC-switch combination - DiSEqC A, DiSEqC B etc.;
– Or give analogue operating combination - TonBurst A, TonBurst B.
To change operating from DiSEqC for analogue do what recommended for particular switch.
Please, note:
DiSEqC 2.0 is controlled similar to DiSEqC 1.0.
LNB POWER
On/off LNB power.
MOTORIZED SYSTEM
If you use Motorized System for antenna operating with DiSEqC 1.2, set “On” in this item. The
Motorized System is used to set the DiSEqC 1.2 motor by Eutelsat specification.
INSTALLATION
i
ANTENNA SETUP
15
