MOUNTING SPEAKER COVERS TO THE TUBE
• Mount the speaker covers to the tube as shown in the illustrations below.
TUBE CONNECTION
• Connect the plug of the tube to the plug of the cables coming out at the back
of your unit.
• Insert the tube in your unit as shown in the illustration until it clicks in place.
Make sure that the connection cable is put behind the tube in the system.
To disconnect the tube, insert the two supplied tools as shown, and take the
tube out of your system.
POWER SUPPLY CONNECTION
• Only connect the unit to a 230V~, 50/60 Hz a.c. power source.
• Always ensure that the voltage indicated on the unit's rating plate agrees with
you local power supply. If this is not the case, consult your dealer or
customer service center. The rating plate is found on the back of the unit.
CONNECTING OTHER EQUIPMENT
Before connecting any other programme sources, always switch off Space
Fidelity. In addition, note the correct connection of the stereo channels:
R
: right (red)
L
: left (white).
AUX IN/OUT
Connect the LINE OUT sockets of your other equipment, e.g. tape
-or DAT recorder, TV, DSR tuner, etc. to the sockets
AUX IN
.
Connect the LINE IN sockets of your other equipment, e.g. tape -
or DAT recorder to the sockets
AUX OUT
.
ANTENNA CONNECTION
Only a good antenna system (broadband cable connection to your own antenna
system, or a common house antenna system) can guarantee optimum reception
quality, especially for FM stereo broadcasts.
FM 75
Ω
• The
FM 75
Ω
socket is used for connection to the Community or Cable An-
tenna System or to a roof-mounted FM antenna with an impedance of 75 Ohm.
• If non of these are available, you may use the cast (wire) antenna supplied for
nearby station (reception could be poor). You should not, however, change
the length of the cast antenna.
AM LOOP ANTENNA
• For AM reception, connect the supplied wires to the
AM LOOP ANTENNA
terminals and position the antenna for best reception.
• The elevated antenna
b
as well as earth
e
can also be connected to these
sockets in place of the frame antenna.
Note:
do not place the AM loop antenna on the unit, as this unit employs a
computing device which could cause interference.
FM 75 AM LOOP ANTENNA
FM
T
O
P
SIDE
OBEN
1
1
2
2
TO
P S
ID
OBEN
©
21
INSTALLATION
GB