- Record Video Clip:
Check this item and select a video recording storage type, <SD Card> or <NAS> (Network-Attached Storage). The
alarm-triggered recording will be saved onto the microSD card or the NAS.
The pre-trigger buffer recording function allows users to check what happened to trigger the alarm. The pre-
trigger buffer time range is from 1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after the alarm is triggered. The setting range is from 1
to 99999 seconds.
Select <Upload while trigger is active> to record the triggered video until the trigger is turned off.
NOTE: Please make sure that local recording (with Micro SD/ SDHC card) or the remote recording (with NAS) is
activated so that this function can be implemented. See section 9.10. Recording (on Camera) for further details.
- Send Message by FTP:
The Administrator can select whether to send an alarm message by FTP when Network Failure is detected.
- Send Message by E-Mail:
The Administrator can choose to send an alarm message by E-Mail when Network Failure is detected.
Save :
After completing all the settings mentioned above, please click on the Save button to save all the settings in this
page.
9.8.4. Tampering
The Tampering Alarm function helps the IP Camera against tampering such as deliberate redirection, blocking,
spray paint, lens covering, etc. through video analysis and reaction to such events by sending out notifications or
uploading snapshots to the specified destination(s).
47
English
Summary of Contents for GCI-M0566F
Page 2: ......
