Water softener
GENO-mat duo WE-X,
GENO-mat duo WE-OSMO-X
Order no. 074 184 046-inter Edited by: phar/mrie G:\BA-184046-inter_074_GENO-mat duo_WE-X.docx
24
2.1 Filling the exchanger
tank
The work described here is only needed with the large systems .
Smaller units are supplied with filled exchanger tanks.
Table D-1: Filling in resin
450 / 330
750 / 530
Amount of resin per
exchanger container
115 l
200 l
Centre riser pipe, fill with resin
1. Check whether the riser pipes are covered by protective
caps, plug on protective caps, if necessary.
Protective caps prevent material from entering the riser
pipes.
2. Centre riser pipes in the exchanger containers.
3. Pour ion exchange resin into the tanks. Use the funnel
provided.
Remove the protective cap,
fix the control valve in place
4. Centre the riser pipes precisely.
5. On the exchanger containers, clean any adhering ion
exchanger resin off the threads and sealing connections for
the connections of the control valve or bottle adapter.
6. Remove the protective caps from the riser pipes.
7. Guide the control valve from above with its head nozzle over
the riser pipe of the right exchanger tank (as seen from the
front) and secure by turning clockwise.
8. Guide the bottle adapter from above with its head nozzle
over the riser pipe of the left exchanger tank (as seen from
the front) and secure by turning clockwise.
9. Install connecting pipes between control valve and bottle
adapter.
Summary of Contents for GENO-mat duo WE-OSMO-X 130
Page 2: ......
