12
11
Step 1: Check the ground, make sure that the ground is level, then place the base at the
position where it needs to be installed, and keep the base level.
Step 2: Place the first battery on the base.
Step 3: Stack the second battery on the first battery, stack the third battery on the second
battery, and so on, until all the batteries are installed.
Step 4: Make sure that all the batteries are aligned, then use a screwdriver to open the
connectors on the left end of the batteries, rotate the connector position, and connect
the upper and lower battery modules together.
4.5 Installation
4.5.1 Floor Standing Installation
1) The battery base is required while installing the battery system/ La
base de la batterie est requise lors de l'installation du système de
batterie.
2) The maximum quantity of stacking battery pack is 10, if it exceeds
10, please install them by.
3) the way of multiple clusters in parallel/ La quantité maximale de
batterie d'empilage est de 10, si elle dépasse 10, veuillez les installer
par le biais de plusieurs clusters en parallèle.
4) Please install indoors and ensure the level of the ground/ Veuillez
installer à l'intérieur et assurer le niveau du sol.
Fig 4.5: Multiple AXE 5.0L with base installation process
4.5.2 Electrical Connection
Ø
Do not forget wear ESD wrist strap and gloves, safety gloves and
goggles/ N'oubliez pas de porter un bracelet antistatique et des gants,
des gants de sécurité et des lunettes de protection.
Ø
It is recommended that the power line and communication line
between the battery and the PCS should not exceed 2 meters/ Il est
recommandé que la ligne électrique et la ligne de communication entre
la batterie et le PCS ne dépassent pas 2 mètres.
WARNING
4.5.2.1 Communication interface definition:
Item
Crystal head picture
Serial no.
Definition
PCS
1
/
2
/
3
GND_COM
4
CAN_H
5
CAN_L
6
GND_COM
7
WAKE-
8
WAKE+
4.5.2.2 Single cluster wiring
PCS
Link-in
L
in
k
-o
u
t
To PCS CAN
Fig 4.6: Block diagram of a single
cluster system
Fig 4.7: Single cluster communication wiring
Installation Method
Compound Mode
Single cluster installation
A*M+B+C
Floor installation into N columns
A*M+B*N+C*N
Note:
"M" means the number of batteries, "N" means the number of clusters.
WARNING
Avertissemen
Battery-
PE
CAN communication
AXE 5.0L Cable
To PCS
Avertissemen
